Redeploying Incomplete Applications using Application Deployer

This topic describes the procedure to redeploy incomplete applications using Application Deployer.

While deploying an application, if Revert on Failure check box is not selected and the application fails to load completely, it is shown in the Deployment Overview page as Incomplete. Such applications can either be redeployed or undeployed.

1. On CUSP > My Applications, click (Application Deployer). A Deployment Overview page is displayed.
2. Click (Incomplete) in the Deployment Overview window. The list of applications which are not completely deployed is displayed in the Applications List section.
   Note: The count of the Incomplete applications will be displayed as zero if there are no incompletely deployed applications.
3. You can do any of the following:
   • Right-click the required application and select Deploy. The application will start deploying from where it stopped earlier.
   • Right-click the required application and select 'Undeploy'. An Application Undeploy wizard is displayed. Click Next and proceed with undeploying the application package

Based on your selection, the applications will be redeployed or undeployed.